1. O NE or triaxial not walking or not walking properly
1. Control whether it is loose or damaged.
2: drive shaft corresponding to defects.
3. Defects of corresponding shaft stepper motor.
4: the corresponding joint is broken or loose.
5: the corresponding screw nut cracked or became defective.
6. Defects are presented on the axis relative to the slider.
7: driver subdivision, current and software setup are different.
2. Depth and depth of P olish are different
1. Control whether loose or defective
2: approaching motor step defects
3: driver failure or current subdivision caused by software Settings
4. Avdeev – shaft motor line defect
5. Motor defects of spindle
6: converter interference or incorrect data setting
7: electrostatic interference
8: computer viruses or system problems
3. C Ivan
1: control card defect
2: converter interference
3: wrong way to file
4: electrostatic interference
5: set up problematic software
6: drive defect or current breakdown setting is incorrect
7: defect of data cable
8: the computer has a virus or system problem
4. Small pindle stop
1: internal short circuit of spindle
2: current shield
3. Incorrect parameter Settings of frequency converter, or its own shortcomings
4: control card defects
5: short circuit of spindle or data cable
His machine can’t be put in place properly
1: in the opposite direction
2: defects or looseness of the control card
3: limit switch or data line failure
4: driver defects
5. Approaching defect of motor step
If you need more information about nc routing machines, please do not hesitate to contact us.
Post time: Nov-08-2018